Technical Specifications - ResMed Quattro FX NV User Manual

Technical Specifi cations
Deadspace: Empty volume of mask to the elbow. The deadspace of the mask varies
according to cushion size.
Quattro FX NV
243mL (Large)
Therapy pressure (cm H O)
2
Quattro FX NV
4 – 30
Gross Dimensions – Mask fully assembled – no headgear. Largest variant only
shown.
Quattro FX NV
Height 140 mm
Width 176 mm
Depth 144 mm
Environmental conditions – all masks:
Operating temperature: +5°C to +40°C
Operating humidity: 15% to 95% non-condensing
Storage and transport temperature: -20°C to +60°C
Storage and transport humidity: up to 95% non-condensing
Notes:
• The mask system does not contain latex, PVC or DEHP materials
• The manufacturer reserves the right to change these specifi cations without notice.
Storage
Ensure that the mask is thoroughly clean and dry before storing it for any length
of time. Store the mask in a dry place out of direct sunlight.
To maintain optimum care of your mask, ensure the spring frame support is fi tted
when travelling.
Disposal
The mask does not contain any hazardous substances and may be disposed of
with your normal household refuse.
Symbols
The following symbols may appear on the mask or packaging.
Caution, consult accompanying documents;
number; European Authorised Representative;
limitation; Humidity limitation;
Indicates a Warning or Caution and alerts you to a possible injury or explains
special measures for the safe and eff ective use of the device.
rain; This way up; Fragile, handle with care.
Warnings
• The mask must be used under qualifi ed supervision for users who are unable to
remove the mask by themselves.
• The mask is not for use on patients with impaired laryngeal refl exes or other
conditions predisposing to aspiration in the even of regurgitation or vomiting.
• The mask should not be worn unless the ventilator system is turned on and
operating properly.
• At a fi xed fl ow rate of supplemental oxygen fl ow (if used), the inhaled oxygen
concentration varies depending on the pressure settings, user breathing
pattern, mask size selection and leak rate.
• If oxygen is used with the ventilator, the oxygen fl ow must be turned off when
the ventilator is not operating so that unused oxygen does not accumulate
within the device enclosure and create a risk of fi re.
• Discontinue using the mask and consult your physician or sleep therapist if you
have ANY adverse reaction.
• If any visible deterioration of a mask component is apparent (cracking, tears,
etc), the mask component should be discarded and replaced.
• Do not use aromatic-based solutions or scented oils (eg, eucalyptus or essential
oils), bleach, alcohol or products that smell strongly (eg, citrus) to clean any of
the mask components. Residual vapours from these solutions can be inhaled
and may also damage the mask, causing cracks.
8
LOT REF
Lot number; Part
Temperature
Does not contain latex; Manufacturer;
Keep away from