Quick Setup - Planet Networking & Communication CS-2000 Quick Installation Manual

4. Quick Setup

STEP 1:
Connect both the Administrator's PC and the LAN port of the Content Security Gateway
to a hub or switch. Make sure there is a link light on the hub/switch for both connections.
The CS-2000 has an embedded web server used for management and configuration. Use
a web browser to display the configurations of the Content Security Gateway (such as
Internet Explorer 4 (or above) or Netscape 4.0 (or above) with full java script support).
The default IP address of the Content Security Gateway is 192.168.1.1 with a subnet
mask of 255.255.255.0. Therefore, the IP address of the Administrator PC must be in
the range between 192.168.1.2– 192.168.1.254.
By default, the CS-2000 is shipped with its DHCP Server function enabled. This means the
client computers on the LAN network including the Administrator PC can set their TCP/IP
settings to automatically obtain an IP address from the Content Security Gateway.
The following table is a list of private IP addresses. These addresses may not be used as
a WAN IP address.
10.0.0.0 ~ 10.255.255.255
172.16.0.0 ~ 172.31.255.255
192.168.0.0 ~ 192.168.255.255
STEP 2:
Once the Administrator's PC has an IP address on the same network as the Content
Security Gateway, open up an Internet web browser and type in
in the address bar.

http://192.168.1.1