Cdr Statistics; Quick Setup Wizard; Network Configuration; Local Network - Planet Networking & Communication VGW 20FS Series User Manual

CDR Statistics

3.3.5
CDR (Call Detail Record) is a data record produced by a telephone exchange or a telecommunication
device, which contains the details of a telephone call that passes through the device.
On the Status & Statistic  CDR interface, details of all calls through the ports of the VGW-X20FS
SERIES are displayed. The CDR function can be enabled on this interface.

3.4 Quick Setup Wizard

Quick setup wizard guides user to configuring the device step by step. User only needs to configure
network, SIP server and SIP port in the Quick Setup Wizard interface. Basically, after these three
steps, user is able to make voice call via the VGW-X20FS SERIES device.

3.5 Network Configuration

Local Network

3.5.1
The VGW-X20FS SERIES gateway has two kinds of network mode: route and bridge. When the
gateway works in the route mode, it will work as a small router and NAT function is enabled. Under
this situation, WAN port is normally connected to router/switch or ADSL MODEM, while LAN port is
connected local computer or other network devices (such as Ethernet switches, hubs, etc.).
When the gateway works in the bridge mode, WAN port and LAN port are the same. The gateway
serves as a two-port Ethernet switch. In this network mode, user only needs to configure the IP
address of WAN port and DNS.
DHCP:
Obtain IP address automatically.
Static IP Address:
Static IP address is a permanent IP address which is assigned by Internet Service Provider (ISP) and
remains associated with a single computer over an extended period of time. This differs from
a dynamic IP address, which is assigned ad hoc at the start of each session, normally changing from
one session to the next.
4-/8-/16-/24-/32-Port SIP Internet Telephony Gateway
24