Removing A Filler Panel From A Switching Fabric Module Slot - H3C S12501X-AF Manual

To install a filler panel in a switching fabric module slot:
1. Loosen the captive screws on the ejector levers and rotate outward the ejector levers.
2. Orient the filler panel with the side marked "Up" up. Hold the filler panel front panel near the
ejector levers with one hand and support its bottom with the other. Place the filler panel bottom
gently on guide rails at the chassis bottom. Align the filler panel with the switching fabric module
slot. Push the filler panel slowly into the slot along the guide rails. See callout 1 in
Keep the filler panel parallel to the switching fabric module slot to avoid touching other
components in the chassis.
3. As shown by callout 2 in
levers touch the slot edges tightly. Simultaneously rotate the ejector levers inward.
4. Fasten the captive screws on the ejector levers.
Figure 13 Installing a filler panel in a switching fabric module slot (S12516X-AF switch)
(1) Push the filler panel slowly into the slot
(3) Fasten the captive screws on the ejector levers

Removing a filler panel from a switching fabric module slot

1. As shown by callout 1 in
2. As shown by callout 2 in
part way out of the slot.
3. As shown by callout 3 in
filler panel out of the slot.
Keep the removed the filler panel secure for future use.
Figure 13, continue to push the filler panel until the brakes on its ejector
Figure 14, loosen the captive screws on the ejector levers.
Figure 14, rotate outward the ejector levers. Then pull the filler panel
Figure 14, hold the filler panel by the top and bottom edges to pull the
17
(2) Simultaneously rotate the ejector levers inward
Figure 13.