Removing A Filler Panel From A Switching Fabric Module Slot - H3C S12500X-AF Series Quick Start Manual

To install a filler panel in a switching fabric module slot:
1. Loosen the captive screws on the ejector levers and rotate outward the ejector levers.
2. Orient the filler panel with the side marked "Up" facing up. Hold the filler panel front panel near
the ejector levers with one hand and support its bottom with the other. Place the filler panel
bottom gently on the bottom guide rails of the chassis. Align the filler panel with the switching
fabric module slot. Push the filler panel slowly into the slot along the guide rails. See callout 1
in Figure
Keep the filler panel parallel to the switching fabric module slot to avoid touching other
components in the chassis.
3. As shown by callout 2 in
ejector levers touch the slot edges tightly. Simultaneously rotate the ejector levers inward.
4. Fasten the captive screws on the ejector levers.
Figure 23 Installing a filler panel in a switching fabric module slot (S12516X-AF switch)
(1) Push the filler panel slowly into the slot
(3) Fasten the captive screws on the ejector levers

Removing a filler panel from a switching fabric module slot

1. As shown by callout 1 in
2. As shown by callout 2 in
part way out of the slot.
3. As shown by callout 3 in
filler panel out of the slot.
Keep the removed the filler panel secure for future use.
23.
Figure
Figure
Figure
Figure
23, continue to push the filler panel until the brakes on its
(2) Simultaneously rotate the ejector levers inward
24, loosen the captive screws on the ejector levers.
24, rotate outward the ejector levers. Then pull the filler panel
24, hold the filler panel by the top and bottom edges to pull the
25