Installing FRUs
This section describes the installation procedures for the LPUs, fan trays, and power modules. For
the compatibility matrix between these modules and the switch models, see H3C S12500X-AF
Switch Series Installation Guide.
WARNING!
Long-time exposure to strong air flow might cause discomfort. As a best practice, do not stand close
to the air outlet vents while the switch is operating. If you must be next to the switch on the air outlet
vent side for an extended period, avoid the air flow or take other protective measures.
CAUTION:
For good ventilation of the switch, install filler panels in empty card and power module slots.
Attaching an ESD wrist strap
To prevent electronic components from ESD damage, wear an ESD wrist strap and make sure it
makes good skin contact and is reliably grounded before you install FRUs.
Installing an LPU
CAUTION:
The switch comes with the LPU slot installed with a filler panel. If you are not to install an LPU in the
slot, keep the filler panel in slot.
The S12500X-AF H LPUs are available for the switch.
Removing the filler panel
1.
Loose the captive screws that secure the filler panel to the slot. See callout 1 in
2.
As shown by callout 2 in
Keep the removed filler panel secure for future use.
Figure 7 Removing the filler panel
Figure
7, remove the filler panel.
8
Figure
7.