Whirlpool RB16 PXB Use And Care Manual page 24

6. Use the Hour and Minute pads to set the
desired stop time. Push the "up" (A) or
"down" (V) pad(s) until the correct time
shows on the display.
This example shows a desired stop time of
2:30. This provides a cook time of 30
minutes (the difference between the start
and stop times).
NOTE: If you do not set a stop time, the
colon will flash on the display and STOP and
COOK will flash alternately to remind you to
program a stop time or a cook time. (See
page 21 for instructions on how to set delay
start and stop automatically using Cook
Time and Start Time.)
7. Push the Start/Enter pad. DELAY and
BAKE will light up on the display to indicate
that the oven is programmed to start at a
later time.
NOTE: The display will show "door" and a
tone will sound once a minute for 5 minutes
if the door is latched when you try to bake/
roast.
You can change the temperature or time
settings any time after pushing the Start/
Enter pad by repeating any of Steps 2
through 6.
8. When the start time is reached, a one-
second tone will sound and DELAY will go
off. The display will show the set cook time.
"Loo", HEAT, TIMED, and BAKE will light up
on the display to show that the oven is
heating. The display will count down the
baking/roasting time in minutes.
9. When the baking/roasting time is com-
pleted, the oven will turn off automatically,
beep four times, and "End" will show on the
display. You will also hear four l-second
tones every minute until you push the Off/
Cancel pad.
NOTE: To disable reminder tones, push and
hold the Cook Time pad for 4 seconds. To
reactivate tones, repeat this procedure.
To cancel the MEALTIMER" control setting:
l
Push the Off/Cancel pad to return the display
to the time of day.
24