Ariens GRAVELY Pro-Turn 400 Series Dealer/Owner/Operator Manual page 36

1. Steering Lever Assembly
2. Steering Lever Stop
Figure 27
Adjust Forward Position
(Figure 28)
1. Shut off engine. Remove the ignition
key.
2. Loosen pivot bolt and angle adjustment
bolt.
3. Rotate the steering lever assembly to
desired forward lever position.
4. Tighten hardware.
IMPORTANT: Ensure that both levers are
aligned and do not make contact with each
other
1
2
1. Pivot Bolt
2. Angle Adjustment Bolt
Figure 28
ADJUSTING THE UNIT TO TRACK
STRAIGHT
2
Check and adjust tire pressure. Increase
pressure on side unit tracks to. DO NOT
exceed maximum recommended tire
pressure (see Specifications on page 46).
1
If tire pressure adjustment does not solve
tracking problem, adjust the limiter bolts on
the stop bracket (Figure 29). Front bolts
adjust forward and rear bolts adjust reverse.
Lengthen the limiter bolt (move closer to
lever) on side which is too fast.
1. Limiter Bolt
2. Jam Nut
3. Steering Lever
4. Stop Bracket
ADJUSTING THE PARKING
BRAKE
The parking brake should not need
adjustment, however if the parking brake
does not hold the unit properly, the brake may
need adjustment.
Check Adjustment
NOTE: Be sure to check the parking brake on
both sides of the unit (Figure 30).
1. Engage parking brake and set both
transmission bypass valves to the
neutral position. See To Push The Unit
on page 23.
2. Push the unit forward.
EN - 36
WARNING: Prior to adjusting the
tracking of the unit, shut OFF
engine, engage parking brake,
and remove the ignition key.
3
2
1
Figure 29
4