Ariens GRAVELY Pro-Turn 400 Series Dealer/Owner/Operator Manual page 33

Table of Contents

Advertisement

2. Place battery on bench or other well-
ventilated place.
3. Connect positive (+) lead of charger to
positive (+) terminal, and negative (–)
lead to negative (–) terminal.
4. Charge battery according to charger and
battery manufacturers' instructions.
5. Replace battery. See Replace Battery on
page 32.
Jump-Starting
Gravely does not recommend jump-starting
your unit. Jump-starting can damage engine
and electrical system components. See your
engine manual for more detailed information.
ELECTRICAL SERVICE
Replacing Fuses
(Figure 22)
IMPORTANT: AVOID DAMAGE! When
replacing fuses use only replacements with
the same amperage rating or you may
damage the circuit.
The unit is equipped with fuses to protect the
multiple circuits. The fuses are located in the
fuse box on the right side of the seat.
1. Remove defective fuse from socket.
2. Check metal clip in fuse window and
discard fuse if clip is broken.
3. Install new fuse of equal amperage
rating into socket.
Replacing Relays
(Figure 22)
NOTE: (Relays are interchangeable. Use
only quality replacement relays (see
SERVICE PARTS on page 45).
The unit is equipped with relays located in the
fuse box on the right side of the seat.
1. Remove defective relay from socket.
2. Install new relay into socket.
4
2
3
1. Fuse Box
2. Start Relay
3. Starter Solenoid Relay
4. PTO Relay
5. 10-Amp Fuse (Run Circuit)
6. 10-Amp Fuse (Power Seat Circuit)
7. Fuel Relay
8. 10-Amp Fuse (PTO Circuit)
9. 15-Amp Fuse (Auxiliary Circuit)
STEERING CONTROL NEUTRAL
ADJUSTMENT
Eliminating Excessive Creeping of
the Unit
(Figure 23)
WARNING: This adjustment
requires operating the engine.
Use extreme care to avoid
contact with moving parts and hot
surfaces. Be sure rear of unit is
well supported and secure before
starting engine.
1. If hydraulic system is cold, run unit for a
minimum of five minutes, then shut off
engine.
2. With the unit up to and facing a wall, lift
the unit so that both drive wheels are off
the ground.
3. Remove the drive wheels from the unit.
EN - 33
1
5
7
8
Figure 22
6
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents