Ariens GRAVELY Pro-Turn 400 Series Dealer/Owner/Operator Manual page 21

4
5
1. Arm Rest Angle Adjustment Knob
2. Back Rest Angle Adjustment Lever
3. Lower Arm Rest Mounting Location
4. Higher Arm Rest Mounting Location
5. Back Lumbar Support Adjustment Knob
Figure 8
Back Rest Angle
The seat back rest angle can be adjusted to
accomodate operator preference.
• Rotate the adjustment knob (item 2)
clockwise to tilt seat back forward.
• Rotate counter-clockwise to adjust
seatback angle backward.
Back Lumbar Support
The seat back lumbar support can be
adjusted to provide additional back support
for the operator.
• Rotate the adjustment knob (item 5)
clockwise to increase the amount of
lumbar support.
• Rotate counter-clockwise to decrease
the amount of lumbar support.
Seat Retainer Adjustment
(Figure 9)
Damage to the seat isolators may occur if
units are operated for an extended period of
time with the seat retainer threaded washer
1
adjusted too far from the isolator.
The correct adjustment for the seat retainer
threaded washer is 1/8 – 1/4 inch below the
bottom of the isolator mount
2
Adjust to 1/8 – 1/4" (3 – 6 mm)
gap between threaded washer
and seat isolator.
3
1. Threaded Washer
2. Seat Isolator
HOUR METER
Measures and displays (1) the amount of time
engine has been run, time spent on jobs and
service intervals. This time cannot be
cleared.
Operation
1.Timer (TMR1)
Measures the time spent on individual jobs.
Press and hold the toggle button to reset the
timer to zero. TMR1 will then start measuring
engine run time until it is reset to zero again.
2.Service Alert
Displays maintenance interval reminders for:
EN - 21
2
Figure 9
Press and release the
1
toggle button (1) to
shift between different
functions.
Press and hold the
toggle button to reset
the timer or clear a
service message.
2
The hour meter has
three functions:
1