Husqvarna X-COM R Workshop Manual page 18

5. Right earmuff: Disconnect the microphone connector
(A) from the circuit board.
A
6. Left earmuff: Disconnect the microphone connector
(B) from the circuit board.
7. Remove the microphone (C) and wind filter (D).
18 - Repair instructions
B
C
D
7.9.2 To install the microphone
1. Assemble the wind filter (A).
2. Put the rubber sealing boot (B) on the microphone.
3. Push the microphone rubber boot and make sure it
aligns with the top of seat in earmuff (C).
C
A
B
893 - 001 -