The Microphone Connector - Husqvarna X-COM R Workshop Manual

1. Make sure to connect the correct end of the strain
relief cable (A) to the circuit board. The 10-pin end
must be connected to the right earmuff and the 9-pin
end must be connected to the left earmuff.
A
2. Assemble the left earmuff. Refer to
left earmuff on page 14 .
3. Assemble the right earmuff. Refer to
the right earmuff on page 13 .

7.6 The microphone connector

7.6.1 To disconnect the microphone connector
1. Disassemble the right earmuff. Refer to
disassemble the right earmuff on page 11 .
2. Disconnect the microphone connector cable from
the circuit board in position (A).
893 - 001 -
7.6.2 To connect the microphone connector
1. Connect the microphone connector cable to the
2. Make sure that the microphone connector (B) is
To assemble the
To assemble
To
3. Assemble the right earmuff. Refer to
A
circuit board in position (A). Put the cable in a loop
as shown in the illustration.
installed in the correct position. Put in the
microphone connector (B) in the earmuff housing.
the right earmuff on page 13 .
A
B
To assemble
Repair instructions - 15