Repair Instructions; To Clean And Examine The Product Parts; To Remove And Install The Headband; The Cable Clip - Husqvarna X-COM R Workshop Manual

7.1 To clean and examine the product parts

• Clean and examine all parts fully. You find more
instructions in the chapter for each part if special
tools or procedures are necessary.
• Replace damaged or defective parts.
• Always use original spare parts.

7.2 To remove and install the headband

1. Remove the cable clip. Refer to
clip on page 10 .
2. Use a screwdriver to open the slot (A).
A
3. Remove the headband (B) from the pin (C).
B
C
4. Install in the opposite sequence.

10 - Repair instructions

7 Repair instructions
To remove the cable

7.3 The cable clip

7.3.1 To remove the cable clip
• Remove the cable clip (A).
A
893 - 001 -