Parameters - Siemens SIMATIC ET 200SP Manual

Chronological sequence
The figure below shows the chronological sequence for oversampling. The output data
present in the CPU is output in the data cycle after the next one, distributed across the sub-
cycles which are generated on the actual module.
n
Sub-
cycle
Figure 4-3
Derating
Read the information on derating of the module in section Derating of the DQ 4x24VDC/2A
HS (Page 95).
4.2.2

Parameters

DQ 4×24VDC/2A HS parameters
The effective range of the assignable parameters depends on the type of configuration.
The following configurations are possible:
● Central operation on an ET 200SP CPU or on an ET 200SP Open Controller
● Distributed operation on PROFINET IO in an ET 200SP system
In addition to assigning parameters with the configuration software, you can also set the
parameters in RUN mode (dynamically) using the user program. When assigning the
parameters in the user program, the "WRREC" instruction transfers the parameters to the
module using data records; see section Parameter assignment and structure of the
parameter data record for oversampling operating mode (Page 104).
Digital output module DQ 4x24VDC/2A HS (6ES7132-6BD20-0DA0)
Manual, 06/2018, A5E32855695-AC
Output values from bus cycle n
4 bit x 32 (max) each = max. 16 bytes output data per data cycle
Oversampling
Oversampling operating mode
4.2 Parameters/address space
35