Panasonic CQ-DF602U Operating Instructions Manual page 51

Setting
Host Name
(DHCP Only)
*1
Default Gateway
(Static/DHCP Only)
DNS Server
*1
Address
(Static/DHCP Only)
Max. Bandwidth
Usage
• If your ISP uses the DHCP function, which
automatically assigns an IP address to the camera,
enter the ISP–assigned host name. (The host name
may be used as an authentication.)
• Enter ASCII characters for the host name (see page
190). Note that [Space], ["], ['], [&], [<] and [>] are not
available.
• If you have been assigned a Default Gateway address
by your ISP or network administrator, enter it in this
data field.
• Set 4 numbers (0—255) and 3 periods, such as
"192.168.0.253". Note that "0.0.0.0" and
"255.255.255.255" are not available.
• The DNS server address is required in the following
situations:
– Transferring camera images by E–mail or FTP
– Setting cameras by their host names on the
Multi-Camera Setup page
– Using the DynamicDNS service
– Using the alarm log notification
• If you have been assigned a DNS server addresses by
your ISP or network administrator, enter them in this
data field. There are usually two addresses.
• Set 4 numbers (0—255) and 3 periods, such as
"192.168.0.253". Note that "0.0.0.0" and
"255.255.255.255" are not available.
• The bandwidth can be restricted.
• Select a maximum bandwidth from [Unlimited] to [0.1
Mbps].
• This setting is valid in both IPv4 and IPv6.
Note
• Set a maximum bandwidth referring to the following file
sizes. These are examples for a JPEG file of standard
image quality. File sizes may change depending on the
image quality or the brightness of the object.
– 160 x 120 pixels: About 3.5 KB (28 Kbit)
– 320 x 240 pixels: About 10 KB (80 Kbit)
– 640 x 480 pixels: About 18 KB (144 Kbit)
Description
Operating Instructions
51