Configuring the AMDC
About this task
Use the following procedure to configure the Active Mobility Domain Controller (AMDC).
Procedure
1. Configure the VLAN using the following command input:
2. Associate ports to the configured VLAN using the following command input:
3. Configure MultiLink Trunking (MLT) using the following command input:
4. Create the VLAN IP interfaces using the following command input:
5. Associate the management VLAN using the following command input:
6. Enable routing using the following command:
7. Enable TELNET and SNMP access using the following command input:
8. Configure the wireless system interface with the following command input:
Avaya WLAN 8100 Configuration
WC8180(config)#vlan configcontrol flexible
WC8180(config)#vlan create 20 name mgmt type port
WC8180(config)#vlan create 30 name system type port
WC8180(config)#vlan create 128 name employee type port
WC8180(config)#vlan create 129 name voice type port
WC8180(config)#vlan create 130 name guest type port
WC8180(config)#vlan ports 1,2 tagging tagAll filter-untagged-frame enable
WC8180(config)#vlan members add 20 1,2
WC8180(config)#vlan members add 30 1,2
WC8180(config)#vlan members add 128 1,2
WC8180(config)#vlan members add 129 1,2
WC8180(config)#vlan members add 128 1,2
WC8180(config)#vlan members add 130 1,2
WC8180(config)#mlt 1 name toCORE member 1/1,1/2 learning disable
WC8180(config)#mlt 1 enable
WC8180(config)#interface vlan 20
WC8180(config-if)#ip address 20.1.1.51 255.255.255.0
WC8180(config)#interface vlan 30
WC8180(config-if)#ip address 30.1.1.51 255.255.255.0
WC8180(config)#vlan mgmt 20
WC8180(config)#ip route
WC8180(config)#ip route
WC8180(config)#ip routing
WC8180(config)#telnet-access enable
WC8180(config)#snmp-server enable
WC8180(config)#wireless
WC8180(config-wireless)#interface-ip 30.1.1.51
WC8180(config-wireless)#enable
Configuring an Enterprise Wireless LAN using CLI
0.0.0.0 0.0.0.0 30.1.1.1 1
0.0.0.0 0.0.0.0 30.1.1.1 enable
August 2011
7