Configuring The Bmdc - Avaya WLAN 8100 Configuration

Configuring an Enterprise Wireless LAN using EDM
21. Enter the Access Point details (including MAC address, Serial number, and the AP
22. Map the MV to local VLANs. Navigate to Wireless > Mobility Switch > Vlan Map. To
23. Navigate to Configuration > Wireless > Controller and select the Config Sync tab.
24. In the Action field, select start to start Config Sync across the domain.

Configuring the BMDC

About this task
Use the following procedure to configure the Backup Mobility Domain Controller (BMDC) using
Enterprise Data Manager (EDM).
Procedure
1. Log on to Enterprise Device Manager (EDM).
2. Configure the VLAN by navigating to Configuration > VLAN > VLANs. Click Insert
3. Associate ports to the configured VLAN.
4. Configure MultiLink Trunking (MLT) by navigating to Configuration > VLAN > MLT/
5. To create the VLAN IP interfaces navigate to Configuration > VLAN >VLANs.
6. Associate the management VLAN. AUTHOR: Could not find how to do this in
7. Navigate to Configuration > VLAN > VLANs. The VLAN screen appears on the
8. In the Routing column, select true from the drop down menu to enable routing on
20 Avaya WLAN 8100 Configuration
profile number you want the device associated to) and click Insert to add the Access
Point.
map the Mobility VLAN to LVID, click LVID Value for a Mobility VLAN and change
the LVID from 0 to the corresponding Local VLAN ID.
to add a new VLAN.
LACP.
a. Select the MultiLink Trunk you want to enable from the MultiLink Trunk tab.
b. Select the Enable field and change the value to true.
a. Click the IP button on the Basic tab. The IP tab appears.
b. Click Insert and enter the new IP and NetMask.
c. Click Insert to save your changes.
EDM.
right.
each VLAN.
Comments? infodev@avaya.com
August 2011