Configuring The Peer Controller - Avaya WLAN 8100 Configuration

9. Enable TELNET and SNMP access. AUTHOR: Could not find how to do this in
10. Navigate to Configuration > Wireless > System and configure the wireless system
11. Navigate to Configuration > Wireless > Controller. Select MdcCapable, and set the
12. Enter the DomainName and Secret to create and join the domain.
13. Map the MV to the local VLANs. AUTHOR: I couldn't figure out how to do this

Configuring the peer controller

About this task
Use the following procedure to configure the peer controller using Enterprise Data Manager
(EDM).
Procedure
1. Log on to Enterprise Device Manager (EDM).
2. Configure the VLAN by navigating to Configuration > VLAN > VLANs. Click Insert
3. Associate ports to the configured VLAN.
4. Configure MultiLink Trunking (MLT) by navigating to Configuration > VLAN > MLT/
5. To create the VLAN IP interfaces navigate to Configuration > VLAN >VLANs.
Avaya WLAN 8100 Configuration
EDM.
interface. Values to be set are WirelessEnabled (checkbox),
SystemInetAddressType, SystemInetAddress, and TcpUdpBasePort.
Domain Password to elevate the interface to Mobility Controller Domain (MCD)
capable.
Caution:
Before proceeding, ensure "config sync" is executed on the AMDC to sync the
global configuration across the domain.
in EDM.
to add a new VLAN.
LACP.
a. Select the MultiLink Trunk you want to enable from the MultiLink Trunk tab.
b. Select the Enable field and change the value to true.
a. Click the IP button on the Basic tab. The IP tab appears.
b. Click Insert and enter the new IP and NetMask.
c. Click Insert to save your changes.
Configuring an Enterprise Wireless LAN using EDM
August 2011 21