Installing The Hob; Safety Instructions For The Installer - Samsung C61RA Series User Manual

Installing the Hob

Important: Be sure the new appliance is installed and grounded only by qualified
EN
personnel. Please observe this instruction. The warranty will not cover any damage that
may occur as a result of improper installation. Technical data is provided at the end of
this manual.

Safety instructions for the installer

• A device must be provided in the electrical installation that allows the appliance to be
disconnected from the mains at all poles with a contact opening width of at least 3 mm. Suitable
isolation devices include line protecting cut - outs, fuses (screw type fuses are to be removed
from the holder), earth leakage trips and contactors.
• With respect to fire protection, this appliance corresponds to EN 60335 - 2 - 6. This type of
appliance may be installed with a high cupboard or wall on one side.
• Drawers may not be fitted underneath the hob.
• The installation must guarantee shock protection.
• The kitchen unit in which the appliance is fitted must satisfy the stability requirements of DIN
68930.
• For protection against moisture, all cut surfaces are to be sealed with a suitable sealant.
• On tiled work surfaces, the joints in the area where the hob sits must be completely filled with
grout.
• On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place
with a suitable artificial resin or mixed adhesive.
• Ensure that the seal is correctly seated against the work surface without any gaps. Additional
silicon sealant must not be applied; this would make removal more difficult when servicing.
• The hob must be pressed out from below when removed.
C61R2AEEP_BOL_DG68-00125D-04_EN_161107.indd 10
10
2016-11-07 10:57:08