Power On/Off; Ttl Mode - Rollei HS Freeze 6 Instructions Manual

Professional studio flash unit with rechargeable battery

Hide thumbs Also See for HS Freeze 6:

Table of Contents

Available languages

Operation

Power on / off

• Switch on: Press and hold the power button for about 2 seconds until the

LCD screen will light up and enters the operation interface .

• Switch off: Press and hold the power button for about 2 seconds until the

LCD screen will become totally black .

1 . Enter Menu 1 and press the second function button repeatedly until the display

shows TTL on the LCD .

2 . Press the third function button to change the sync mode . Choose between

normal mode or high speed mode .

3 . Enter Menu 2 to set the channel and the group of the flash .

4 . Choose the wireless remote control mode according to the trigger that you use .

5 . The exposure value can be adjusted from -3 .0 up to +3 .0 directly on the flash by

rotating the power output knob . The value can be adjusted by 1 f-stop increment

by pushing the power output knob once and then turning it around (clockwise

to increase the value and counter clockwise to decrease the value) . But the value

can also be adjusted by 1/10 f-stop by just turning the power output knob .

Note: If you use a trigger the value of the flash will not be overwritten by the value

set on the trigger . For example if your flash shows an EV of +1 .0 and your trigger

shows a value of +2 .0, then the picture will have a real exposure value of +3 .0 .

If the flash shows an EV of +3 .0 then you are able to even get a higher exposure

value by setting the trigger to also +3 .0 and then the maximum exposure value of

+6 .0 will be reached . The same goes for the negative exposure values .

Table of Contents