Easy Cap Mode - Rollei HS Freeze 6 Instructions Manual

Operation

Easy Cap Mode

The Easy Cap Mode can be used to easily cut out the main subject from the back-
ground with the help of an image processing software (not part of the delivery) .
Please note that therefore there are needed at least 2 flashes .
1 . Activate the Easy Cap mode on your flash .
2 . Set the number of groups that are needed . Therefore press the corresponding
function button and rotate the dial to change the value . The maximum setting of
the groups is limited to 6 (All6), but within each group the quantity of flashes is
unlimited .
3 . Then set the sequence of the groups . Therefore press the corresponding function
button and change the value by rotating the knob . Here you set the sequence of
when the flash will be released . After the setting the groups will flash according
to this sequence .
Example (working with 4 flashes)
1 . There are 2 groups related with Easy Cap mode, therefore the group setting is
set to „All2" .
2 . There are two flashes which will be the main flashes and they are set to „No1"
(group 1) . Then they will be triggered with the first frame (see figure 1 – correctly
exposed picture) .
3 . The two background flashes are set to „No2" (group 2) and they will not be
triggered in the first frame but in the second one (see figure 2 – no exposure on
main subject, only the background) .
4 . With the help of an image processing software, the main subject can now be
quickly cut out from the background .
1
2
31