Removing The Speaker; Installing The Speakers - Dell Vostro 3888 Service Manual

Installing the slim ODD bracket
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the slim ODD bracket and provides a visual representation of the installation procedure.
Steps
1. Align and place the ODD bracket on the ODD slots.
2. Snap the ODD bracket into the ODD.
Next steps
1. Install the Side cover.
2. Follow the procedure in After working on your computer.
Speaker

Removing the speaker

Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the speakers and provide a visual representation of the removal procedure.
Steps
1. Disconnect the speaker cable from the connector on the system board.
2. Unroute the speaker cable from the routing guides on the chassis.
3. Press and slide the speaker along with the cable from the slot on the chassis.

Installing the speakers

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speakers and provides a visual representation of the installation procedure.
Steps
1. Press and slide the speaker in the slot on the chassis until it snaps into place.
2. Route the speaker cable through the routing guide on the chassis.
3. Connect the speaker cable to the connector on the system board.
Next steps
1. Install the Side cover.
2. Follow the procedure in After working on your computer.
Disassembly and reassembly 45