Removing The Memory Modules - Dell Vostro 3888 Service Manual

Steps
1. Remove the screw (M2x3) that secures the solid-state drive to the system board.
2. Slide and lift the solid-state drive off the system board.
Installing the M.2 2280 PCIe solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the installation procedure.
Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive connector.
2. Insert the solid-state drive at a 45-degree angle into the slot on the system board.
3. Replace the screw (M2X3) to secure the M.2 PCIe solid-state drive to the system board.
Next steps
1. Install the Side cover.
2. Follow the procedure in After working on your computer.
Memory modules

Removing the memory modules

Prerequisites
1. Follow the procedure in before working inside your computer.
Disassembly and reassembly 29