Table of Contents
Advertisement
Jumper Settings
Jumper
Description
1-2: Normal
3-pin CLEAR CMOS
JP1
2-3: Clear
Before clearing the CMOS,
make sure to turn the sys-
tem off.
JP3
2-pin BIOS Write
OPEN: Disable
Protect
SHORT: Enable
JP4
3-pin
LAN Function
Setting (default)
1-2: Enable
2-3: Disable
Installing the Motherboard
Connecting a Case Components
After you have installed the motherboard into a case, you can begin con-
necting the motherboard components. Refer to the following:
1. Connect the CPU cooling fan cable to CPUFAN1.
2. Connect the Northbridge cooling fan connector to PWRFAN1.
3. Connect the case cooling fan connector to SYSFAN1.
4. Connect the case speaker cable to SPK1.
5. Connect the case switches and indicator LEDs to the PANEL1.
If there are three pins in the case LED cable, connect to SJ1.
6. Connect the standard power supply connector to ATX1.
7. Connect the auxiliary case power supply connector to ATX12V.
CPUFAN1/PWRFAN1/SYSFAN1: FAN Power Connectors
Pin
Signal Name
Function
1
System Ground
GND
2
Power +12V
+12V
3
Sensor
Sense
7
Advertisement
Table of Contents
