Playback Procedure - Panasonic PV-D744S Operating Instructions Manual

Playback procedure

NOTES:
•
If a non-compatible disc is loaded, "Incorrect Disc", "Region Code Error" or "Parental Error" will appear on the TV
screen according to the type of loaded disc. In this case, check your disc again (See pages 6 and 47).
•
Some discs may take a minute or so to start playback.
•
A "Prohibition" symbol
tried is not available on the disc, or the DVD/VCR can not access the feature at this time. This does not indicate
a problem with the DVD/VCR.
• When you set a single-faced disc label downwards (ie. the wrong way up) and press PLAY or OPEN/CLOSE,
"Reading" will appear and remain on the screen for approx. 40 seconds and then it will change to "Incorrect Disc".
•
Some playback operations of DVDs may be intentionally fixed by software producers. Since this DVD/VCR plays
DVDs according to the disc contents the software producers designed, some playback features may not be
available. Also refer to the instructions supplied with the DVDs.
•
When playing DTS-encoded Audio CDs, excessive noise will be heard from the analog stereo outputs. To avoid
possible damage to the audio system, the consumer should take proper precautions when the analog stereo
outputs of the DVD/VCR are connected to an amplification system.
36
Preparation:
• Turn ON the TV and set to the video input mode.
•
Press VCR/DVD to select the DVD mode. (The DVD indicator
will light.)
1
Press OPEN/CLOSE.
The disc tray will open.
2
Place a disc onto the tray.
Hold the disc, position it with the
printed label side up, align it with
the guides, and place it in its
proper position.
3
Press PLAY or OPEN/CLOSE.
The disc tray closes automati-
cally.
On the screen,
"Reading" and then playback will
commence.
• A menu screen may appear on
4
Press STOP to end playback.
• The DVD/VCR memorizes the stopped point, depending on
• If you press STOP again ("
5
Then press OPEN/CLOSE.
The disc tray opens.
Remove the disc and press POWER.
The disc tray closes automatically and DVD/VCR turns off.
may appear at the upper left of the screen. This symbol means either the feature you
changes to
the TV screen, if the disc has
a menu feature. In this case,
press , , ,
ENTER to operate a menu
feature.
the disc. " " appears on the screen for approx. 4 seconds.
" " keep blinking in the display until the playback is stopped
completely. Press PLAY to resume playback (from the scene
point).
load the disc, the DVD/VCR will clear the stopped point.
Reading
or
" appears on the screen) or un-