Contents Of Delivery; Transport And Start Up; Transport And Installation; Assembly - Jet DDS-225 Operating Instructions Manual

The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of the
hazards and risks involved only.
4.4 Content of delivery
Machine with closed cabinet stand
1 abrasive strip 100mm, 80 grit
1abrasive strip 100mm, 100 grit
1 handwheel
1 gear box handle
2 dust ports 100mm
Assembly kit
Operating manual
Spare parts list.

5. Transport and start up

5.1 Transport and installation

Remove the screws holding the
sander to the pallet and use a forklift
or hoist to lift the sander off the pallet.
DO NOT lift directly under the drums
or rollers, as it may damage them.
The machine is designed to operate in
closed rooms and must be placed
stable on firm and levelled ground.
The machine can be bolted down if
required.

5.2 Assembly

If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
a mild solvent.
Handwheel assembly
See Fig 1
Fig 1
Dust ports and installation
Mount the two dust ports (A) to the top
of the hood.
Fig 2
Gear box handle installation
Screw the handle (C) into the collar of
gearbox (D)
Fig 3
Abrasive strips installation
See chapter 7.1

5.3 Mains connection

Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
16A surge-proof fuse.
Only use connection cables marked
H07RN-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
The machine is equipped with power
cord and 16A CCE Euro plug.
Attention :
-Check first if the sanding drums run
freely and if all safety devices are
fitted before starting the machine.
5
- If the direction of rotation is not
correct, the phase converter inside the
CCE Euro plug must be pushed in and
turned 180°.
(See rotation arrow on machine for
correct rotation)

5.4 Dust connection

Before initial operation, the machine
must be connected to a dust extractor.
The suction should switch on
automatically when the sander is
switched on.
The flow rate on the 100mm suction
ports must be 20m/sec.
Flexible hoses must be of non-
flammable quality, and must be
connected to the machine ground
system.

5.5 Starting operation

Turn ON the lockable main power
switch. (rotation switch).
You can start the machine with the
green On-button. The red Off-buttons
stops the machine.
The conveyor motor is started and
stopped simultaneously with the main
motor.
In case of machine overload the motor
overload cut-off will react.
After appr.10 min of cooling the
machine can be started again.
The feed gearbox handle (C, Fig 3)
engages the conveyor.
Pos 1.....Low ( 2 m/min)
Pos 2.....High ( 3 m/min)
Pos 0.....Feed Off
The height adjustment handle raises
or lowers the conveyor table to the
desired depth of cut.

6. Machine operation

Correct operating position:
To feed the workpiece into the
machine, position yourselves offset to
one side of the feed opening.
Workpiece handling:
Feed stock form the infeed side and
against the rotation of the drum.
It will then be automatically feed
through the machine.
Feed with thicker workpiece end at the
front, hollow side downward.