Table of Contents
Advertisement
Centre above floor without risters
Overall (LxWxH)
Net weight
Mains
Output power
Reference current
Extension cord (H07RN-F):
Installation fuse protection
Isolation class
4.3 Noise emission
Acoustic pressure level (EN ISO 11202):
Idling
In operation
The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
As workplace conditions vary, this information is intended to
allow the user to make a better estimation of the hazards and
risks involved only.
4.4 Content of delivery
Lathe bed with headstock, tool support and tailstock – A
350mm Tool rest – B
Legs – C
Spur center – D
Live center – E
Live cone center – F
Live cone center pin – G
Knockout rod – H
75mm Faceplate – J (installed on lathe)
Tool rest extension – K
Faceplate wrench – L
Levelers – M
Tool shelf – N
Riser Blocks - P
Hardware:
Socket hd. cap screws, 5/16x1-1/4 – HP1*
8
Lock washers, 5/16 – HP2*
8
Flat washers, 5/16 – HP3*
8
Socket hd. cap screws, 3/8x1-1/4 – HP4
2
Lock washers, 3/8 – HP5
2
* included in JWL1440-HP1, hardware package
1130mm
1854 x 1334 x 508 mm
190 kg
1~230V, PE, 50Hz
1,5 kW (2 HP) S1
8 A
3x1,5mm²
16A
I
LpA 72,5 dB(A)
LpA 78,4 dB(A)
5. Transport and start up
5.1 Transport and installation
The machine is designed to operate in closed rooms and
must be placed stable on firm and levelled ground.
The machine can be bolted down if required.
For packing reasons the machine is not completely
assembled
5.2 Assembly
If you notice transport damage while unpacking, notify your
supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly manner.
Clean all rust protected surfaces with a mild solvent.
Attach the leg stand:
At this point the headstock, tailstock and tool rest should be
removed.
Unscrew the stud (N, Fig 4) from each end of bed.
Fig 2
Advertisement
Table of Contents
