Contents Of Delivery; Transport And Start Up; Transport And Installation; Assembly - Jet JWL-1015 Operating Instructions Manual

The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
As workplace conditions vary, this information is intended to
allow the user to make a better estimation of the hazards and
risks involved only.
4.4 Content of delivery
Live centre
Spur centre
Tooling knockout bar
150 mm tool rest
75 mm face plate
Operating manual
Spare parts list.

5. Transport and start up

5.1 Transport and installation

The machine is designed to operate in closed rooms and
must be placed stable on firm and levelled surface.
For safety reasons, the machine must be bolted to the work
bench or to the optional stand.
For packing reasons the machine is not completely
assembled

5.2 Assembly

Fig 2
Fig 3
If you notice transport damage while unpacking, notify your
supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly manner.
Clean all rust protected surfaces with a mild solvent.

5.3 Mains connection

Mains connection and any extension cords used must comply
with applicable regulations.
The mains voltage must comply with the information on the
machine licence plate.
The mains connection must have a
10A surge-proof fuse.
Only use power cords marked H07RN-F
Connections and repairs to the electrical equipment may only
be carried out by qualified electricians.

5.4 Dust collection

Use a suitable dust collection and air filtration system to avoid
high dust concentrations in the air.

5.5 Starting operation

You can start the machine with the green ON-button
(D, Fig 4).
The machine will stop when you push the red OFF button (C).
Wait for the workpiece to come to a complete stop.
JWL-1015VS only:
The variable speeds of the lathe are controlled by the speed
control knob (A, Fig 4) as well as the position of the belt on
the pulleys.
Fig 4