Husqvarna Rider 213C Workshop Manual page 41

8. Loosen the hose from the transmission oil tank.
Open the clamp for the suction pipe below the tank
and remove the hydraulic tank.
9. Loosen the cable and the speed control rod from the
lever.
10. Remove the clutch control. Refer to
front transmission on page 39 .
11. Remove the transmission belt. Refer to
the transmission belt on page 53 .
12. Remove the 5 screws that hold the rear transmission
and lower the rear transmission.
934 - 002 - 25.06.2019
9.5.9.4 To assemble the rear transmission
Obey the instructions in
clean on page 36 .
1. Assemble the rear transmission in opposite
2. Lubricate the axles with corrosion protection before
To assemble the
3. Lightly lubricate the pipe couplings before you
To remove
4. Fill with oil and bleed the hydraulic system. See
5. Do a check of and adjust speed coordination
9.5.10 To replace the shaft seals of the hydrostatic
transmission
9.5.10.1 To replace the input shaft seal of the
hydrostatic transmission
1. Remove the cooling fan circlip and then the cooling
2. Lift the belt pulley up from the input shaft and
3. Clean all the dirt and corrosion from the input shaft
To keep the hydraulic system
CAUTION: Hold the connection nut with a
wrench to prevent damage to the pipes or the
elbow nipples.
sequence in relation to disassemble. See
disassemble the rear transmission on page 40 .
attaching the wheels.
Note: The spacer sleeves in the wheels have
different lengths. Left: 36.3 mm + washer. Right:
45.5 mm, no washer. Do not mix up with the front
axle spacer sleeves.
assemble.
bleed the drive system on page 37 .
between the front wheels and rear wheels. See
adjust the wheel speed on AWD products on page
30 .
CAUTION: The area around the seal must be
clean. Dirt in the transmission oil can decrease
the lifetime of the hydrostatic transmission.
fan.
remove the circlip below the belt pulley.
and the area around the seal.
To
To
To
Repair instructions - 41