Husqvarna Rider 213C Workshop Manual page 40

5. Attach the front speed adjustment rod.
6. Lightly lubricate the pipe couplings before you
assemble.
7. Lubricate the axles with corrosion protection before
you attach the wheels.
Note: The spacer sleeves in the wheels have
different lengths. Left: 36.3 mm + washer. Right:
45.5 mm, no washer. Do not mix up with the rear
axle spacer sleeves.
8. Fill the transmission oil tank with oil and bleed the
hydraulic system. Refer to
on page 37 .
9. Do a check of and adjust the parking brake cable.
To adjust the parking brake on AWD
Refer to
products on page 22 .
10. Do a check of and adjust speed coordination
between the front wheels and rear wheels. Refer to
To adjust the wheel speed on AWD products on
page 30 .
9.5.9.3 To disassemble the rear transmission
To keep the hydraulic system
Obey the directions in
clean on page 36 .
CAUTION: Hold the hydraulic connection nuts
with a wrench to prevent damage to the pipes or
elbow nipples.
Note: A small quantity of oil can leak although the
transmission is drained.
1. Put support below the product. Refer to
supports below the product on page 6 .
2. Remove the rear wheels. Refer to
install the wheels on page 22 .
40 - Repair instructions
To bleed the drive system
To put
To remove and
3. Drain the oil of the rear transmission. Refer to
Transmission maintenance on page 45 .
4. Remove the filter lid and pull out the filter. Replace
Technical data on page 59 .
the filter. Refer to
5. Make marks on the hydraulic hoses to make it easier
to connect them correctly when you assemble them.
6. Disconnect the hydraulic hoses from the rear
transmission.
7. Attach protective plugs in the transmission and the
hoses.
934 - 002 - 25.06.2019