Husqvarna Rider 213C Workshop Manual page 27

9. Remove the transmission belt spring from the belt
tensioner.
10. Lift the transmission belt from the tension pulley.
11. Remove the engine pulley covers on the left and
right side of the product. Do not mix the screws.
12. Remove the belt guide for the engine belt pulley.
934 - 002 - 25.06.2019
13. Hold the belt pulley with a counterhold and remove
the Allen screw that holds the belt pulley and engine
Servicing tools on page 15
together. Refer to
14. Loosen the belt pulley from the engine shaft. Use a
puller if it is necessary. Refer to
page 15
15. Remove the 4 engine fixtures.
16. Lift the engine to remove it.
17. Install the engine in the opposite sequence.
Note: The belt pulley groove must align with the
output shaft key. Make sure that the spacer pipe (A)
Servicing tools on
Repair instructions - 27