6.
Tighten the nuts carefully to prevent
damaging the adjuster screw.
7.
Refit the spring (A).
8.
The parking brake should be checked
again after the adjustment has been
made.
!
WARNING!
A poorly adjusted parking brake
can result in reduced braking
ability.
Adjusting the Hydrostatic
Transmission Cable
The hydrostatic transmission cable (on the left
side) is adjusted in the following manner:
1.
Remove the transmission cover. Loosen
both screws (one on each side) and lift off
the transmission cover.
2.
Take apart the ball joint, which is locked with
a locking spring.
3.
Ensure that the forward drive pedal is
pressed down completely.
4.
Switch the vertical arm to the maximum
position and check that the ball and socket
in the ball joint are aligned.
5.
Adjust the socket on the cable as needed,
so that it fits precisely over the ball on the
lever arm.
6.
Assemble the ball joint.
7.
Put the ball joint's locking spring in place.
8.
Tighten the lock nut for the socket on the cable.
IMPORTANT INFORMATION
Make sure that the locking spring goes
through both holes in the socket.
REPAIR INSTRUCTIONS
Transmission cover
The link joint's locking spring
Checking the adjustment of the hydrostatic transmission
cable
41
English-