Detecting The Original Size Automatically; Originals That Are Not Supported By The Adf - Epson WF-C878R Series User Manual

Placing Originals
>

Detecting the Original Size Automatically

When you select Auto Detectas the paper setting, the following types of paper size are identified automatically.
❏ Placing vertically: A4, B5, A5
Place the long edge of the original toward the paper feed entrance of the ADF or the left side of the scanner
glass.
❏ Placing horizontally: A3, B4, A4, B5, A5 (scanner glass only)
Place the short edge of the original toward the paper feed entrance of the ADF or the left side of the scanner
glass.
Note:
The sizes for the following originals may not be detected correctly. If the sizes are not detected, set the size manually on the
control panel.
❏ Originals that are torn, folded, wrinkled, or curled (if the originals are curled, flatten the curl before placing the
originals.)
❏ Originals with a lot of binder holes
❏ OHPs, translucent originals, or glossy originals

Originals that are not Supported by the ADF

Important:
c
Do not feed photographs or valuable original artwork into the ADF. Misfeeding may wrinkle or damage the
original. Scan these documents on the scanner glass instead.
To prevent paper jams, avoid placing the following originals in the ADF. For these types, use the scanner glass.
❏ Originals that are torn, folded, wrinkled, deteriorated, or curled
❏ Originals with binder holes
❏ Originals held together with tape, staples, paper clips etc.
❏ Originals that have stickers or labels stuck to them
❏ Originals that are cut irregularly or not right angled
❏ Originals that are bound
❏ OHPs, thermal transfer paper, or carbon backs
Originals that are not Supported by the ADF
43