Counter Control Group And Alarm Counter Control - Siemens FS720 Configuration

'Control' task card
12

Counter control group and alarm counter control

Parameters
'2nd message'
'Language of the 2nd
message'
12.5 Counter control group and alarm counter control
230 | 412
Building Technologies
Fire Safety
Values
The voice messages that
can be selected
correspond to those for the
first voice message. See
the entry further up in this
table.
The languages that can be
selected correspond to
those for the first voice
message. See the entry
further up in this table.
See also
2 System behavior [➙ 255]
2 Prioritized voice evac. control [➙ 218]
2 Phased voice evac. control [➙ 205]
The 'Counter control group' groups the control elements 'Alarm counter control'.
With the 'Alarm counter control', the following events of the ↑ 'Stations' can be
registered:
● ' --All Fire ALARMS'
● 'All test activations'
The 'Counter control group' and 'Alarm counter control' elements are not available
in the 'Control tree' as standard. They must be created, if required. Information on
the creation of 'Control tree' can be found in chapter 'Creating control tree
[➙ 175]'.
Assigning 'Alarm counter control'
The 'Alarm counter control' element can be assigned to one or more 'Stations'.
While doing this, one or both event categories of a 'Station' can be assigned.
Figure 69: Assigning alarm counter control
1. Select the 'Control' task card.
2. Open 'Station' > 'Counter control group' in the tree view.
Description
The parameter determines which standard voice
message should be played second when this cause
group is activated.
Information: All available voice messages can be
selected for the 'Causes CUSTOM 1' and 'Causes
CUSTOM 2' cause groups. For all other cause
groups, the selection is restricted to the
corresponding voice message.
You will find more information on the standard voice
messages that can be configured in the
documentation for the sounder and sounder base in
question. See chapter 'Applicable documents'.
The parameter determines the language in which the
second voice message is played.
You will find information on the languages that can
be configured for the standard voice messages in the
documentation for the sounder and sounder base in
question. See chapter 'Applicable documents'.
A6V10210424_j_en_--
2018-08-29