Table of Contents
Advertisement
3.5.8 Reset Operation
There is reset key to be used when user wants to reset system. In normal condition the reset
pin is connected to V
CC
3.5.9 Test Pin
For every pin of MB95F310 there is a test pin connecting to it.
3.5.10 Battery Usage
The supply power is 3.3V for MCU EEPROM and MAX232. The LCD EV-Board uses power
chip AMS1117-3.3 to transfer input power from 5V to 3.3V, so the max battery supply is four
cells (1.5V each cell).
MB2146-450-E Setup Guide
Chapter 3 EV-board Manual
when it is pressed to connect to GND by reset key.
MCU-AN-500072-E-10 – Page 29
Advertisement
Table of Contents
