Stand-Alone Operation - Fujitsu YOKOGAWA AF220 Application Note

6 Stand-alone operation

This chapter describes the Yokogawa Flash-Programmer in stand-alone mode
The Yokogawa Flash-programmer can be used as stand-alone programmer. In this case, the
programmer can be controlled by the integrated keypad.
The basic functions are listed below.
Note that an explicit connect-command does not exist.
Function
Load HEX-file
Blank Check
Erase (including blank-check)
Program
Read Check (Verify)
Automatic (Erase, Program, Verify)
Save HEX-file
Purge file
For further and more specific functions, please refer to the Instruction Manual of the
Yokogawa Flash-programmer.
MCU-AN-390087-E-V10
FLASH PROGRAMMER YOKOGAWA AF220/221
Stand-alone operation
Key-code
[FUNC] F 1 = / > [SET] [FUNC] [SET]
[DEV] 9 [SET] [DEV] [SET]
[DEV] C [SET] [DEV] [SET]
[DEV] D [SET] [DEV] [SET]
[DEV] E [SET] [DEV] [SET]
[DEV] F [SET] [DEV] [SET]
[FUNC] F 2 = / > [SET] [FUNC] [SET]
[FUNC] F 3 = / > [SET] [FUNC] [SET] [SET]
Table 3-3: Basic Functions in stand-alone mode
- 14 - © Fujitsu Microelectronics Europe GmbH