Switch Housing - Hunter 50257 User Manual

Switch Housing

www.HunterFanInternational.com
Feed the wires through the center hole
Partially install two machine screws, found Insert the third screw, found in
of the upper switch housing, then wrap
in the hardware bag, halfway into the
the hardware bag, into place and
the keyhole slots around the screws
motor housing. It does not matter which then tighten all three screws.
and twist counterclockwise.
two screw holes you choose.
Make sure the heat shield assembly is securely attached to
the housing mounting plate. Failure to properly attach and
tighten all three assembly screws could result in the heat
Use only the light fixture supplied with this fan model.
shield assembly and light fixture falling.
12
MB529-01 • 11/15/16 • © 2016 Hunter Fan Company