Table of Contents
Advertisement
Category
The Button
The Host
Problem
The Button
automatically
restarts sometimes.
The LED indicator
on the Button
remains static red
even after it has
been powered on
for 30 seconds.
The pairing function
cannot be executed
via the MODE key
while the Button is
powered on and the
LED starts flashing
red.
Nothing is shown
on the display at all.
Cause
Insufficient power
supply.
The Button has not
been properly
powered off during
the resetting process
The display is
switched off.
The wrong input is
selected.
The display cable is
not connected
properly.
The display fails to
show the Host's
output resolution at
1080p in "Guide
Screen" or "Idle
Screen".
The Host is in
Network Standby
Mode when network
standby function is
enabled.
Solution
• Make sure you use USB 3.0 as
the power supply for the
Button.
• If the USB 2.0 port is the only
option for the power supply
for the Button, try to reduce
the power consumption of the
Button by changing Picture
Quality Mode to Low
Power in Web Management.
Reset the Button.
Switch on the display.
Select the correct input.
Insert the HDMI cable between
the Host and the display device
again.
Replace the display with a new
one that supports output
resolution at 1080p.
Press the Present key of the
Button to start presentation.
Troubleshooting
69
Advertisement
Table of Contents
