Advertisement
LIGHT KIT
Use extreme caution if it becomes necessary to operate the unit, transporting or mowing, after dark or in low light
situations. Only operate in open areas where there are no overhead obstructions; i.e. guide wires, tree branches,
low overhangs, etc. Operate only in areas where the operator is thoroughly familiar with the terrain and any poten-
tial hazards. The lights are designed to illuminate forward and down and will not illuminate to the side or upward.
ASSEMBLY:
1. Park the mower on a solid, level surface; lower the deck to the lowest position; set the
park brakes; shut-off the engine; and remove the ignition key. (Disconnect the nega-
tive battery cable.)
2. Remove the existing foot rest and the floor panel to access the wire harness path.
3. Insert the headlights into the new foot rest and secure with the provided hardware.
FIG. 1
4. Insert the two wire harness leads up through the mower frame from below. Connect
the lights to the wire harness. FIG. 1
1
Foot rest
2
Cap Screw
3
Light
4
Nut
Existing Hardware
2
3
2
3
Light Wire Harness
1
4
FIG. 1
121672 REV. A
Existing Hardware
2
Advertisement
