Advertisement
Quick Links
LIGHT KIT
PART NUMBER: 121505
PACKING LIST:
Listed below are parts included in this kit. If any parts are missing or damaged, please contact the
®
Hustler
Parts Department. Retain these instructions for replacement parts.
1
2
6
7
INDEX NO.
PART NO.
1
605209
CS #8-32 X .500 PH TRX
2
605208
NT #8-32 HX NL ZN
3
000331
WIRE TIE
4
604307
PUSH BUTTON MOUNT
5
605405
PUSH MOUNT
6
120384
FOOT REST
7
605003
LIGHT
8
605294
WIRE HARNESS
3
4
DESCRIPTION
121672
5
8
QTY
4
4
10
3
2
1
2
1
INSTRUCTION
REV. A
Advertisement
Related Manuals for HUSTLER 121505
Summary of Contents for HUSTLER 121505
- Page 1 INSTRUCTION 121672 REV. A LIGHT KIT PART NUMBER: 121505 PACKING LIST: Listed below are parts included in this kit. If any parts are missing or damaged, please contact the ® Hustler Parts Department. Retain these instructions for replacement parts. INDEX NO.
- Page 2 LIGHT KIT 121672 REV. A Use extreme caution if it becomes necessary to operate the unit, transporting or mowing, after dark or in low light situations. Only operate in open areas where there are no overhead obstructions; i.e. guide wires, tree branches, low overhangs, etc.
- Page 3 LIGHT KIT 121672 REV. A 5. Insert the push button mounts into the mounting holes located in the mower frame. FIG. 2 NOTE: Make sure to insert the push button mounts in from the top of the frame. Push Button Mount FIG.
- Page 4 LIGHT KIT 121672 REV. A 9. Route the light harness along the inside of the front and left side of the mower frame, loosely securing it in place with wire ties. FIG. 4 NOTE: The light harness will need to be pulled tight to allow it to reach the area under the seat.
- Page 5 LIGHT KIT 121672 REV. A Wire Tie Light harness must be routed as shown. Wire Tie Wire Tie Light harness Wire Tie FIG. 5 Wire tie Wire tie Route light harness as shown Push Mount FIG. 6...
- Page 6 LIGHT KIT 121672 REV. A 10. Raise the seat and locate the main harness connector. FIG. 7 11. Remove and discard the plug from the main harness connector. FIG. 7 Plug Main harness connector FIG. 7 12. Pull the light harness, at the light harness connector until all the excess harness is removed from along the mower frame.
- Page 7 LIGHT KIT 121672 REV. A Light harness Light harness connector Push mount Main harness connector Wire tie Wire tie Light harness Wire tie FIG. 8 FIG. 9 18. Tighten all wire ties. 19. Return the seat to the operating position. 20.