Page 7
ACCESSORIES FOR HEAT EXHAUST HOSE ACCESSORIES FOR DRAINAGE...
Page 8
The castors must be installed Lift up This will require 2 people. under the Installation method Note: Install the drainage hose before operating the unit. Remove the drainage cap and store for future use. 1) Take out drainage cap from drainage point at the back of the unit. A.Drain point B.Drain cap 2) Install drainage cap on the end of the drain hose drainage hose.
DRAINAGE METHOD All refrigeration A/C units (portable or fixed) make condensate water (condensation) during their cooling cycle. To remove this water, this unit has a self evaporating function. This feature allows the unit to collect condensation in a tray, then hot air (exhaust air) is passed over the water and it evaporates, it is then discharged outside as humid air through the exhaust hose.
Page 10
out of hoses as it can unit to not operate inefficiently. not be below the exhaust hose hole on the back of the unit.
Page 11
bending DO NOT is bent in too many places, it could easily malfunction BEND AS BELOW...
Page 12
do not operate the unit. please take to a qualified engineer for repair. -10-...
Page 14
to be can set the timer to run the unit for a specified lengh of time and once reached You can set the time between press it again and -12-...
Page 15
or window . Leave Keep to create good ventilation. to effectively cool, close there and the unit will (HEAT on selected models only) is efficient constant -13-...
Page 17
speeds in left. In sleep mode please note that you can only set timer for 1-7 hours If there is a ppcue cut to the unit uma pave cut and on restun a close not cpevate corrctly, please switch off and -15-...
Page 21
.The unit will adjust itself and turn on or achieve level. unit will adjust itself achieve a level. -19-...
Page 22
After the "SET TIMER" is set, the unit turns off at the end off the set period. When the set time is reached, the unit will in the original mode. Press "TIMER", to select "TIME", the screen will display the current time, press "Hr/Min"...
Page 23
There are castors in the bottom of the unit, to enable you to easily move the unit location. Before maintenance, please switch off from the control panel and pull out the plug from the power supply, in order to avoid an electric shock. running efficiency , or more frequently is required.
Page 24
Switch off the unit on the control panel and unplug from the power supply Please use a damp cloth with mild detergent to clean the outer unit. Do not use petrol, oil of any other chemicals to clean the unit, as this will damage the unit.
Page 25
If malfunction occurs, please check the following before returning to your retailer. The power supply is not connec- ted well. or plug The power plug is not inserted fuse. tightly. engineer There is a malfunction of the to replace the power socket. power plug or socket.
Page 26
ADDITIONAL USER NOTES unit ventillated reduction in in a wet area shock. close to a heat source as it will malfunction. -24-...