Connect The Grounding Cable - Juniper SRX550 Quick Start Manual

High memory services

Hide thumbs Also See for SRX550:

Table of Contents

Figure 5: Securing the Chassis to the Rack

5. Check that the mounting brackets on each side of the rack are lined up with each other.

Connect the Grounding Cable

1. Attach an ESD strap to an ESD point and place the other end of the strap around your bare wrist.

2. Connect the grounding cable to a proper earth ground. Place the grounding cable lug over the grounding point on the

upper rear of the chassis.

NOTE:

The device should be permanently connected to ground during normal operation. A licensed electrician

must attach a cable lug to the grounding cable. A cable with an incorrectly attached lug can damage the

device.

3. Secure the grounding cable lug to the grounding point with the screws.

Table of Contents