Trane Voyager Commercial Installation, Operation And Maintenance Manual page 73

Table 45. Test mode states for CV units with modulating hot gas reheat and modulating heat
TEST
STEP MODE FAN
1 FAN ON ON
ECONO-
2 ON
MIZER
3 COOL 1 ON
4 COOL 2 ON
5 COOL 3 ON
6 REHEAT ON
7 HEAT 1 ON
8 HEAT 2 ON
9 RESET
Notes:2 & 3 stage standard efficiency units (excluding 40-50T Std Efficiency CV):
1. For 27.5-35T units, both compressors will be energized during the Cool 2 Step. For 40-50T units, only Compressor 2 will be energized
during the Cool 2 Step.
2. The Reheat Pumpout relay will be energized any time the Reheat circuit is energized in active Cooling Mode.
3. For units with Statitrac installed, the Exhaust Damper will track the Economizer position during Service Test Mode and the Exhaust Fan
will be energized once the Economizer rises above the Exhaust Enable Setpoint.
4. Heating will not be energized during Service Test until the 6 minute VAV Box ON timer has expired.
Notes:5 stage high efficiency units (including 40-50T Std Efficiency CV):
1. Compressor 1 is the smaller compressor on the circuit.
2. Condenser fans are controlled as defined for normal operation.
3. Exhaust fan operates as defined for normal operation based on economizer position.
4. When Compressor 1 is energized with either C1, C2, or with both for 30 minutes continuously, C3 will be required to de-energize for 30
seconds.
RT-SVX34R-EN
COMP COMP
ECON
1 2
MIN OFF OFF
OPEN OFF OFF
MIN ON OFF
MIN ON ON
MIN ON ON
MIN ON ON
MIN OFF OFF
MIN OFF OFF
COMP HEAT PUMP-
3 OUTPUT OUT
OFF OFF OFF
OFF OFF OFF
IN-
OFF OFF
CONTROL
IN-
OFF OFF
CONTROL
IN-
ON OFF
CONTROL
IN-
ON OFF
CONTROL
OFF 50% OFF
OFF 100% OFF
S S t t a a r r t t u u p p
RE-
COOL HEAT VAV
BOX
VALVE VALVE
100% 0% ON
100% 0% ON
100% 0% ON
100% 0% ON
100% 0% ON
50% 50% ON
100% 0% ON
100% 0% ON
73