Transmitter Display During Calibration And Programming; Infrared Remote Controller; Hart Communication - Emerson Rosemount Analytical HART 5081-A-HT Instruction Manual

MODEL 5081-A
1.7 TRANSMITTER DISPLAy DURING CALI-
BRATION AND PROGRAMMING (Figure 1-1)
1. Continuous display of oxygen, chlorine, or ozone read-
ing.
2. Units: ppm, ppb, or % saturation.
3. Current menu appears here.
4. Submenus, prompts, and diagnostic readings appear
hear.
5. Commands available in each submenu or at each
prompt appear here.
6. Hold appears when the transmitter is in hold.
7. Fault appears when the transmitter detects a sensor or
instrument fault.
©
8. flashes during HART communication.

1.8 INFRARED REMOTE CONTROLLER

(Figure 1-2)
1. Pressing a menu key allows the user access to cali-
brate, program, or diagnostic menus.
2. Press ENTER to store data and settings. Press NEXT
to move from one submenu to the next. Press EXIT to
leave without storing changes.
3. Use the editing keys to scroll through lists of allowed
settings or to change a numerical setting to the desired
value.
4. Pressing HOLD puts the transmitter in hold and sends
the output current to a pre-programmed value. Pressing
RESET causes the transmitter to abandon the present
operation and return to the main display.
5. See page 26 for Hazardous Locations information.
1.9 HART COMMUNICATION (Figure 1-3)
The 275, 375, or 475 HART Communicator is a hand-held
device that provides a common link to all HART SMART
instruments and allows access to AMS (Asset Management
Solutions). Use the HART communicator to set up and con-
trol the 5081-A and to read measured variables. Press ON
to display the on-line menu. All setup menus are available
through this menu.
4
8
F
7
A
U
L
T
H
O
L
D
6
CALIBRATE
C A L I b r A t E
E x I T
5
FIGURE 1-1. TRANSMITTER DISPLAy DURING
CALIBRATION AND PROGRAMMING
The program display screen allows access to
calibration and programming menus.
1.
FIGURE 1-2. INFRARED REMOTE CONTROLLER
4/20 mA + Digital
Model 5081
Smart
Transmitter
Hand Held
Communicator
("Configurator")
FIGURE 1-3. HART COMMUNICATION
DESCRIPTION AND SPECIFICATIONS
1
©
ppm
PROGRAM DIAGNOSE
N E x T E N T E R
4.
3.
2.
250
ohm
Control System
Bridge
Computer
SECTION 1.0
2
3
4