Weider WESY93190 User Manual page 11

20. Press a 1 3/4Ó Square Inner Cap (48) into the lower
end of the Left Arm (6) and the Right Arm (5).
CABLE ASSEMBLY
21. Locate and open the parts bags labeled ÒCABLE
ASSEMBLYÓ and ÒPULLEYS.Ó
During steps 19 through 50, refer to the CABLE DIA-
GRAMS on pages 26 and 27 of this manual to verify
proper cable routing. Before beginning this section,
fully unwind the five Cables and identify the Cables
by comparing the lengths and the ends. The approxi-
mate length of each Cable, in inches, is listed after
the key number in the drawing.
IMPORTANT: While assembling the cables, do not
overtighten the bolts and nuts attaching the pul-
leys. The pulleys must be able to turn freely.
22. Insert a 5/16Ó x 1Ó Bolt (97) through the bracket on
the Right Arm (5). Tighten a 5/16Ó Nylon Jam Nut (91)
onto the Bolt.
Find the Butterfly Cable (89)Ñthis is the second
shortest Cable. Slide one end of the Butterfly Cable
onto the 5/16Ó x 1Ó Bolt (97). Thread another 5/16Ó
Nylon Jam Nut (91) onto the Bolt, but do not fully
tighten it. Leave enough room between the two
Jam Nuts for the Cable to pivot.
20
5
6
48
48
21
87Ñ72Ó
89Ñ82Ó
85Ñ101Ó
86Ñ110Ó
88Ñ239Ó
22
91
89
5
97
11