Weider WESY49202 User Manual page 9

12. Press a 25mm Round Inner Cap (49) into one
of the Press Arms (46). Press a 45mm
Square Inner Cap (44) into the Press Arm.
Attach the Press Arm (46) to one side of the
Press Frame (17) with two M8 x 60mm Bolts
(22) and two M8 Nylon Locknuts (3).
Assemble the other Press Arm (46) in the
same manner.
13. Identify the Right Arm (48) and the Left Arm
(47). Note the position of the welded bracket
on each Arm. Arm identification is very
important for step 14.
Press a 70mm Plastic Bushing (89) into the
Right Arm (48). Attach a "V"-Pulley (50) and a
Long Cable Trap (31) to the Right Arm with an
M10 x 55mm Bolt (86) and an M10 Nylon
Locknut (21). Do not tighten the Locknut
yet.
Assemble the Left Arm (47) in the same
manner.
14. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right
Arm with the Left Arm (47); refer to step 13
to identify the Right Arm. Be sure that the
upper end of the Right Arm is behind the
indicated bracket on the Top Frame (55).
Tap two 25mm Retainers (69) and a 25mm
Round Cover Cap (70) onto the axle. Be sure
that the teeth on the Retainers bend
toward the Round Cover Cap, as shown in
the inset drawing.
Attach the Left Arm (47) in the same manner.
Press 45mm Square Inner Caps (44) into the
lower ends of the Right and Left Arms (47,
48). Wet the lower end of each Arm with
soapy water. Slide a Large Foam Pad (45)
onto the lower end of each Arm.
12
46
13 86
31
50
89
21
48
14
48
44
45
9
44
49
46
22
3
17
47
Welded
Brackets
55
Bracket
Lubricate
Axle
69
45
70
44
Axle
69
47
70