Weider 831.15395.0 User Manual page 6

2. Attach a Wheel (31) to the outside of the Base (1)
with a 3/8" x 4 1/4" Bolt (81), three 3/8" Washers
(75), and a 3/8" Nylon Jamnut (103). Do not
overtighten the Jamnut; the Wheel must be
able to turn easily.
Attach the other Wheel (not shown) in the same
manner.
3. Press a 1 1/2" x 2 1/2" Inner Cap (41) into each
end of the Cross Tube (11).
Orient the Cross Tube (11) as shown, with the
welded tubes at the bottom. Attach the Cross
Tube to the Upright (3) with two 3/8" x 5 1/2"
Carriage Bolts (73), two 3/8" Washers (75), and
two 3/8" Jamnuts (57).
4. Press a 1 1/2" x 3" Inner Cap (99) into the top of
the Front Leg (6). Press the Front Leg Foot (27)
onto the bottom of the Front Leg. Note that the
front of the Front Leg Foot is taller than the
back.
Press a 1 1/2" x 3" Inner Cap (99) into the end of
the Bench Rail (5).
Attach the Bench Rail (5), with the hook on the
bottom, to the Front Leg (6) with two 3/8" x 2"
Carriage Bolts (61) and two 3/8" Nylon Jamnuts
(103).
5. Lubricate a 3/8" x 4" Bolt (66) with grease. Attach
the Bench Rail (5) to the Upright (3) with the Bolt
and a 3/8" Nylon Jamnut (103). Do not over-
tighten the Jamnut; the Bench Rail must be
able to pivot easily.
Tighten the Storage Knob (30) into the Upright (3)
and the Bench Rail (5).
2
3
3
41
73
73
4
99
61
6
Front
27
5
Insert the bolt
through this hole
5
6
103
75
75
31
1
57
75
Welded
Tube
11
41
5
103
Hook
103
30
103
Lubricate
81
99
3
66