Weider 148 User Manual page 9

11. Lubricate the M10 x 75mm Bolt (46). Attach the Leg
Lever (4) to the Front Leg (8) with the Bolt, two M10
Washers (53) and the M10 Nylon Locknut (54).
12. Press two 25.4mm Round Inner Caps (59) into
each Short Pad Tube (10). Press a 25.4mm Round
Inner Cap into each end of the Long Pad Tube (41).
Insert the Short Pad Tubes into the holes in the Leg
Lever (4). Slide two Foam Pads (40) onto each Pad
Tube.
Insert the Long Pad Tube (41) into the holes in the
Front Leg (8). Slide a Foam Pad (40) onto each
end of the Long Pad Tube.
13. Press a 1Ó Square Inner Cap (52) into the indicated
end of each Backrest Tube (5).
Attach each Backrest Tube (5) to the Backrest (6)
with two M8 x 40mm Screws (50) and two M8
Washers (20). The Backrest Tubes must be ori-
ented as shown (note the position of the indi-
cated holes).
14. Press a 1Ó Square Inner Cap (52) into each end of
the Support Tube (7). Note: Make sure the ÒUÓ-
shaped cutout is lined up with the welded pin
inside the Support Tube.
Set the Support Tube into the highest set of adjust-
ment brackets on the Uprights (1, 16).
Lubricate the M10 x 130mm Bolt (9). Attach the
Backrest Tubes (5) to the Frame (2) with the M10 x
130mm Bolt, two M10 Washers (53) and an M10
Nylon Locknut (54). Do not overtighten the Nylon
Locknut.
Rest the Backrest (6) on the Support Tube (7).
11
54
4
12
40
10
40
59
13
50
20
5
14
52
1
LubricateÑ9
53
5
9
53
46
8
53
41
4
59
8
40
59
52
50
20
6
Holes
7
Cutout
6
16
53
54
40
52