Assembly - Weider 148 User Manual

Weight bench
Table of Contents

Advertisement

Assembly

Before beginning assembly, carefully read the
following information and instructions:
¥ Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
¥ Tighten all parts as you assemble them, unless
instructed to do otherwise.
¥ For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART on the previous page.
¥ As you assemble the weight bench, be sure that
all parts are oriented as shown in the drawings.
1. Before assembling this product, be sure that
you have read and understand the information
in the box above.
Press three 38mm Square Inner Caps (57) into the
open tubes on the Front Base (29).
Attach the Rear Base (27) to the Front Base (29)
with two M10 x 60mm Bolts (47), four M10 Washers
(53), a Support Plate (14) and two M10 Nylon
Locknuts (54).
Insert both M8 x 50mm Carriage Bolts (45) up
through the indicated holes in the Front Base (29).
2. Attach the Crossbar (3) to the Right Upright (1) with
two M10 x 70mm Bolts (48), four M10 Washers
(53), a Support Plate (14) and two M10 Nylon
Locknuts (54). The Upright must be oriented as
shown. Note that the welded tube extends
beyond the edge of the Upright on one side.
Attach the Crossbar (3) to the Left Upright (16) in
the same manner.
Press a 50mm Square Inner Cap (56) into the lower
end of each Upright (1, 16). Note: Make sure the
ÒUÓ-shaped cutout is lined up with the lower
hole in the Upright.
Note: The terms ÒRightÓ and ÒLeftÓ are used in
reference to a person sitting on the seat, facing
the lat tower (see page 4). They do not corre-
spond to right and left on the drawings in the
manual.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
¥ Two (2) adjustable wrenches
¥ One (1) rubber mallet
¥ One (1) standard screwdriver
¥ Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
1
29
57
45
2
Welded
Tube
Extends
53
48
53
14
53
Cutout
6
47
53
14
53
53
27
53
54
57
1
16
Welded
54
Extends
3
53
14
54
56
53
56
Tube
53
48

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Webe14871

Table of Contents