Before First Use - IKEA LAGAN Manual

ENGLISH
• The indicators
• The indicator
3. Wait until the indicators
off. The indicator
• The indicator shows the current
setting:
deactivated.

Before first use

1. Make sure that the current level of the
water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the baskets.
After starting a programme, it
may take up to 5 minutes for the
appliance to recharge the resin
in the water softener. It seems
that the appliance is not working.
The washing phase starts only
after this procedure is completed.
The procedure is repeated
periodically.
The salt container
Caution! Use rough salt
designed for dishwashers only.
Fine salt increases the risk of
corrosion.
The salt is used to recharge the resin in the
water softener and to assure good washing
results in daily use.
and are on.
flashes.
and
still flashes.
off = AutoOpen is
4. Press the programme button to change
the setting.
•
are
5. Press on/off to confirm the setting.
Filling the salt container
1
3
Put 1 litre of water
in the salt container
(only for the first
time).
on = AutoOpen is activated .
2
4
Put 1 kg of salt in
the salt container.
12